Concrete Contractors in Hinton, IA

Hinton is a small Plymouth County city that our concrete contractors cover between Sioux City and Le Mars. A post office has run here since 1870, and the town was named by a settler from Hinton, West Virginia. Its population was 808 in 2000, 928 in 2010 and 935 in 2020. Housing units grew from 319 to 374 between 2000 and 2010, then held at 375. So Hinton has a solid block of homes built in the 2000s, plus older houses near the center.

Homes from the 2000s growth

The homes added in the 2000s are now around twenty years old. That is the age when driveways and patios poured by the builder start to show wear. Typical signs include cracks that wander across the slab instead of following joints, edges that crumble where the slab was thin, and patios that have settled toward the house.

If the slab is mostly sound, sealing the cracks and resealing the surface buys years. If it has settled or broken in several places, replacement with a better base and proper joint spacing is the better spend.

The Floyd River valley

The Floyd River runs past Hinton on its 112-mile course to the Missouri at Sioux City. Lots near the valley can hold more moisture than lots on higher ground. The town sits at about 1,168 feet. Moist soil under a slab expands when it freezes, so we put extra care into the base: dig out soft material, add gravel, compact it in lifts, and slope the finished slab so water leaves quickly. Hinton also sits higher than the river bottoms along I-29, so on many lots the concern is runoff from higher ground rather than standing water.

Garage and shed slabs for acreage owners

Around a small town like Hinton, plenty of homes have room for a detached garage, a shop or a storage building. Those buildings start with the slab. We pour them with thickened edges where the walls bear, reinforcement through the field, and an apron at the door. If you plan to park heavy equipment, tell us so we can size the thickness and reinforcement for it.

Get a Free Estimate

Patios and stamped concrete

A back patio is one of the most common projects in town. We discuss size first, because most people underestimate how much room a table, chairs and a grill need. Then we choose a finish. Broom finish is simple and affordable. Stamped concrete adds a stone, brick or wood-plank look with color, and we seal it after curing.

Walks and steps

Front steps and walks take the most abuse from snow, salt and shovels. We replace broken steps with consistent risers and a broom finish, and pour new walks at full thickness on a compacted base.

A simple sealing schedule

Sealing is the cheapest way to protect concrete in this climate. New slabs should cure for about a month before the first coat. After that, a penetrating sealer on driveways and walks every few years keeps water and salt from soaking in. Stamped and colored concrete usually gets a film-forming sealer that brings out the color and needs a fresh coat on a similar schedule. Clean the surface first and pick a dry stretch with mild temperatures. If water no longer beads on the surface, it is time to reseal.

Getting started

We check whether the city needs a permit for your project. Then we visit, measure and send a written quote with each part of the job listed. Call (712) 482-2303 to schedule.